Leak Detection in Panmure

Clear space beneath the affected fixture and around accessible shut-off points before we arrive. Tell us if cupboards are difficult to move or if any valve has previously leaked when operated. We discuss any necessary water interruption so you know which outlets will be unavailable during testing.

Where isolation helps narrow the fault, we test manageable parts of the supply rather than opening finishes immediately. If readings or visible evidence point towards concealed pipework, we explain the likely access required. Locating and confirming a hidden leak can involve opening a wall, floor or other surface.

Once checks provide a clearer picture, we explain what was measured, which areas were tested and what remains uncertain. A restriction at one fixture calls for a different repair from a leaking supply pipe. We avoid recommending pipe repairs simply because the pressure feels lower than it used to.

If testing indicates a leak on the incoming private supply, water main repairs may be the appropriate next step. We discuss the affected area, access requirements and proposed repair scope first. Where evidence remains inconclusive, further testing or targeted access may be needed before selecting a repair.

After an agreed repair, we repeat relevant checks at the original problem fixture and any other affected outlets. Comparing performance under similar conditions matters: a tap running alone can behave differently from several outlets running together. We also check the worked-on area for signs of leakage.

At handover, we explain what caused the poor performance where confirmed, what work was completed and whether anything remains unresolved. You receive practical guidance on what to watch for, including renewed pressure loss or dampness. Any further access or investigation is discussed clearly rather than treated as automatic.